How to Solved HP PC Hardware Diagnostics UEFI
Introduction:
HP PC Hardware Diagnostics UEFI. Welcome to our blog post on troubleshooting UEFI problems. Here you need to make sure that your computer is booting correctly and running smoothly. Sometimes UEFI problems can occur. We will tell you why this problem occurs and how to solve it.
Follow Step : HP PC Hardware Diagnostics UEFI. To troubleshoot UEFI problems, first of all you have to open the PC and then disconnect the power connection so that the electricity supply can be stopped. After this, you have to first remove the RAM, then clean it with a rubber and remove the carbon on it. After that, you have to check all the wires of the PC that all the wires are properly placed in the right place. This will correct the connectivity. If any problem occurs due to that, then it will also be solved. After this, you have to take out the hard disk but keep in mind that the wire which came out of the wire connection should be connected to the same wire. Then the hard disk has to be installed back at the same place from where it came out and its wires should also be installed in the right way. Then you have to do the connectivity in the right way and give electricity connection. After connecting the wire, turn on the PC. If this problem is coming due to any wire, then it will be solved in this way.
Symptoms of UEFI Issues:
-
- Boot errors or failure to boot
-
- BIOS settings not saving
-
- Hardware not recognized
-
- System crashes or freezes
Step-1: Check the cable of CPU’s hard disk.
First of all you have to open the CPU by turning off its power and you have to remove its power cable. Then you have to take out the hard disk and tighten its wire back. And put it back in the same place.
Step-2: Cleaning RAM
Now you have to remove the RAM also, then clean it with rubber and put it back.
Step3: Run HP PC Hardware Diagnostics
Restart your HP PC and press the designated key (typically Esc or F2) to enter the UEFI settings
– Navigate to the Diagnostics menu and select “Run UEFI Diagnostics”
– Follow the prompts to complete the diagnostic take a look at
Step 4: Check UEFI Settings
– Ensure UEFI settings are set to default
– Verify boot order and device priorities
– Save adjustments and go out UEFI settings
Step three: Update UEFI Firmware
– Visit HP’s aid website to test for UEFI firmware updates
– Follow commands to down load and set up the update
Step 5: Disable and Re-allow UEFI Secure Boot
– Enter UEFI settings and navigate to the Security menu
– Disable Secure Boot, store modifications, and reboot
– Re-allow Secure Boot and store adjustments
